Due to the growing population, economic growth, and socioeconomic development, energy is an essential need. Worldwide, about 86.4% of energy is produced by fossil fuels. Globally, India ranks fourth among the countries that have wind energy. The last five years’ growth in wind energy in India is about 16%. This growing Indian wind energy market is compared with the world scenario along with the state of Maharashtra in India, which is in the second position in the country, backed up by a detailed database. The wind is used to produce electricity by converting the kinetic energy of air in motion into electricity. In modern wind turbines, wind rotates the rotor blades, which convert kinetic energy into rotational energy. This rotational energy is transferred by a shaft to the generator, thereby producing electrical energy. An ill-effect of the usage of conventional energy sources to meet the demand is the loss to the environment and public health. The result of pollution like global warming, skin cancer, etc., has forced the scientific community all over the world to focus on alternative sources of energy which can be renewed and should cause considerably less damage to the environment.
The wind is air in motion. The uneven temperature distribution due to solar radiation and the earth’s rotation are the two leading causes of wind. Wind energy is a renewable, inexhaustible, and non-polluting source of energy. It is an environment-friendly, developing, and popular alternative source of clean energy. As a source of power, the potential of wind energy is huge. This is clear from the rapid increase in cumulative global capacity, reaching 539 GW at the end of 2017 representing 10.7% of cumulative market growth. The Ministry of New and Renewable Energy (MNRE), the Government of India, and several state governments have been at the forefront of providing the necessary policy support and a facilitative regulatory system for the fast and orderly growth of the sector. The MNRE took various initiatives to promote cooperation with other countries and funding authorities, like the World Bank, Asian Development Bank, and United Nations Industrial Development Organization (UNIDO) in the field of renewable energy. Under National Clean Energy Fund (NCEF) program, the ministry has taken up initiatives of wind resource assessment in new and uncovered areas to assess the potential at 100 m level and 500 new wind monitoring stations across the country. The Ministry of New and Renewable Energy along with the National Institute of Wind Energy (NIWE) has announced India’s Offshore Wind Policy and also started planning to encourage a demonstration project. The government is keen on the growth of the wind energy sector in India.
Now, if we start learning about wind energy resources in America we will get that, there are 57,000 wind turbines in the United States, both on land and offshore. Wind turbines can be standalone structures, or they can be clustered together in what is known as a wind farm. While one turbine can generate enough electricity to support the energy needs of a single home, a wind farm can generate far more electricity, enough to power thousands of homes. Wind farms are usually located on top of a mountain or in an otherwise windy place to take advantage of natural winds. The largest offshore wind farm in the world is called the Walney Extension. This wind farm is located in the Irish Sea approximately 19 kilometers (11 miles) west of the northwest coast of England. The Walney Extension covers a massive area of 149 square kilometers (56 square miles), which makes the wind farm bigger than the city of San Francisco, California, or the island of Manhattan in New York. The grid of 87 wind turbines stands 195 meters (640 feet) tall, making these offshore wind turbines some of the largest wind turbines in the world. The Walney Extension has the potential to generate 659 megawatts of power, which is enough to supply 600,000 homes in the United Kingdom with electricity.
Cross complemented product and services providers can be enrolled under this partnership program (Roofing contractor, HVAC contractors, HVLS Fans supplier)Know More
Any individual from consultation fraternity to execution contractors can participate in such a program.Know More
DSA (Direct selling Agent) partnership program provides opportunities to become entrepreneur in COOL ROOFING industries to each and every individual who wants to make their career as freelancers.Know More
I really appreciate Neetu ma’am and the panache Team for giving us a perfect solution to the heat related problems we experienced.
Before the application of cool tops, the temperature level on the store was 52 ° C, but after the application of Cool tops there seemed a reduction in surface temperature by 4 ° C, the temperature in the area where I sit was 40 °C which has reduced to 37 °C, there is a substantial difference in the ambient temperature, Since last 4-5 months I’m not reducing the temperature of my AC below 28 , Even at 28 I couldn’t keep it for long as the room becomes cooler so I keep for few minutes and turn it off . I really appreciate Neetu ma’am and the panache Team for giving us a perfect solution to the heat related problems we experienced.
The result after applying cool tops from panache is you can see the smiling faces of our team after applying the coating system from panache .
This was an old shed so we had a direct roofing installed, no Insulation. We were very much clear after the discussion with Panache team that we should go for cool Tops coating instead insulation so the result is you can see the smiling faces of our team after applying the coating system from panache #GoGreenwithCoolTops
We took the temperature measurement of outside and inside premises. We noticed a good amount like you can say minimum 6 to 8 Deg C temperature difference.
Looking at the Indian climatic condition during summers, where the temperatures were going too high and whenever it goes up to the peak level, the temperature in the factory shop floor rises affecting the efficiency of the workers. We had a thought in our mind that is there any way to control the temperature, then we came across the Panache company and got in touch with them, after explaining them our problem they came to visit our factory. The team is very committed and technically competent to give us the exact solution for the temperature reduction at the factory. We noticed minimum 6 to 8 °C temperature difference. Thereafter, we received positive feedback from the workers so we decided to go ahead with another project in our office premises. As far as execution is concerned, Panache are experts in this domain. They even contacted us after completion of our installation and ensured that we were satisfied with the workmanship. If someone really wishes to reduce temperature in their premises, I would highly recommend Cool Tops coating from panache – I wish them best of luck for their future projects!
Their prices and services are definitely worth the solution given & treatment done with complete transparency.
I have hired Panache services for the waterproofing & Cooling Treatment on one of the roofs of Parul University premises. Their prices and services are definitely worth the solution given & treatment done with complete transparency. I can definitely recommend them to organizations & people looking for thermal comfort along with waterproofing solutions also.
Totally satisfied by the service received.
I am very impressed by their work on how they provide customized solutions for every problem we have & every task they take up.
The Indoor Temperature has decreased to almost 5 °C. Cool Tops provides Cool Buildings without ACs.
In one of our projects, we had a requirement where AC was not viable and people working under that premises were very much disturbed. To solve that problem, we have consulted Panache for the solution. Panache has provided the full proof solution and after the completion of the Cool Tops Installation, we were much relieved. The indoor temperature has decreased to almost 5 degrees. I could say Cool Tops provide Cool buildings without AC.
The experience for the quality of products with consistency is very appreciable.
I am an engineer & contractor taking turnkey projects. We have used Panache’s various waterproofing products & I recommend Panache's Cool Tops, the special 5 coat system which gives thermal comfort with sustainable performance. The experience for the quality of products with consistency is very appreciable.
I really appreciate their efforts for perfection & sound knowledge of the technology.
We have met the Panache Team from one of our friend’s references who have already taken the services. I must say, they are very professional in what they do. I really appreciate their efforts for perfection & sound knowledge of the technology.
A Cool Roof coatings consists of a binder (usually an organic compound or silicone compound) blended with pigments and other additives to provide two main benefits: protection of roof membranes for longer roof life cycles; and reflectivity of solar radiation, for lower air conditioning costs.
The main components of most Cool Roof coatings are the binder, pigment, water and reflective pigments. Water serves as a liquid carrier, which provides viscosity, allowing the pigment and binder to be spread on the roof as a thin coating. The majority of white coatings in use today are water-based coatings
An energy efficient , white, reflective, elastomeric coating manufactured by Panache can reflect up to 92% of visible light, keeping the roof surface much cooler than with aluminum, black, or non-reflective roofing materials. Lower temperatures mean less energy usage, and translate to money saved. Elastomeric roof coatings protect the roof substrate adding years to your roof, plus saves against costly tear-offs and re-roofing.